Arduino 4 Relays Shield 4-channel 5V Relay Module

@ expert peshawar

The Arduino 4 Relays Shield module is compatible with all the Arduino boards, 5V and also 3.3V standards. Arduino 4 Relays Shield is a small current signal control power equipment commonly used electronic module, enabling high-power single-chip control devices are widely used in SCM system to make smart home project; and can be directly plugged into the compatible the use of various types of motherboards, eliminating the patch cable troubles.

 550.00

Category:

The Arduino 4 Relays Shield module is compatible with all the Arduino boards, 5V and also 3.3V standards. Arduino 4 Relays Shield is a small current signal control power equipment commonly used electronic module, enabling high-power single-chip control devices are widely used in SCM system to make smart home project; and can be directly plugged into the compatible the use of various types of motherboards, eliminating the patch cable troubles.

The Arduino 4 Relays Shield is a solution for driving high power loads that cannot be controlled by Arduino’s digital IOs, due to the current and voltage limits of the controller. The Shield features four relays, each relay provides 2 pole changeover contacts (NO and NC); in order to increase the current limit of each output the 2 changeover contacts have been put in parallel. Four LEDs indicate the on/off state of each relay.

The Shield features four relays, each relay provides 2 pole changeover contacts (NO and NC); in order to increase the current limit of each output the 2 changeover contacts have been put in parallel. Four LEDs indicate the on/off state of each relay.

The Arduino 4 Relays Shield doesn’t need external power: it will be provided by the base board, through the 5V and 3.3V pins of the Arduino board used as base.

The relays are controlled by the following Arduino board pins: Relay 1 = Arduino pin 4 Relay 2 = Arduino pin 7 Relay 3 = Arduino pin 8 Relay 4 = Arduino pin 12 The shield features several TinkerKit input/output and communication interfaces. Connecting TinkerKit modules can simplify the creation of a project or a prototype.

Special Note:

When using the For UNO board connected to it, because UNO USB interface is extremely high, should avoid green terminals are shorted its shell.

Features: –

  • Standard For Shield interfaces and shape
  • Can continue to stack other for expansion boards
  • 3 M3 screw positioning holes for easy installation
  • High Drive (5V or 3.3V) normally open contact closure
  • Onboard relay indicator (red)
  • Compatible with all the Arduino boards, 5V and also 3.3V standards
  • Doesn’t need external power
  • Solution for driving high power loads
  • Four LEDs indicate the on/off state of each relay

Arduino 4 Relays Shield Specifications: –

  • Operating Voltage: 5V
  • Coil current consumption: 140 mA (with all relays on, about 35 mA each)
  • Single pole charge over contact maximum current: @ 30 V DC 2A
  • Maximum load voltage: 48 V
  • Maximum switching capacity: 60 W

Datasheet: –

docs.rs-online.com/…/0900766b816e4141.pdf

Package: –

1 x Arduino 4 Relays Shield 4-channel 5V Relay Module

Related Products at majju.pk

Vendor Information

  • Store Name: expert.peshawar
  • Vendor: expert.peshawar
  • Address: Market
    Peshawar
    Khyber Pakhtunkhwa
    25000
  • No ratings found yet!
Arduino 4 Relays Shield 4-channel 5V Relay Module
Arduino 4 Relays Shield 4-channel 5V Relay Module

 550.00

Majju PK
Logo
Reset Password
Shopping cart