NAZE32 FLIGHT CONTROLLER BOARD, 6DOF MULTICOPTER
expert.peshawar
This Naze32 6DOF multirotor flight controller is a fully featured 32-bit multirotor flight controller. Measuring just 36mm x 36mm and weighing just over 7g, this little board is ideally suited to your miniquad projects. The powerful 32-bit STM processor uses Baseflight firmware to ensure your quadcopter stays super stable, even when performing acrobatic manoeuvres. The excellent firmware with the added performance of the 32-bit processor means it will work on almost any multirotor aircraft right out of the box – with no fiddly tuning required.
₨ 2,950.00
Features:
- 3-axis MEMS gyro and accelerometer (MPU6050)
- Pre-soldered header pins
- Flexible motor outputs to support various airframe types
- Up to 8-channel RC input – supports standard receivers PWM,PPM receiver or Spektrum satellite receiver
- Battery voltage monitoring
- Modern 32-bit processor running at 3.3V/72MHz (STM32F103CB)
- 16-Mbit onboard SPI flash
- Onboard micro USB for setup and configuration
- Multi Wii-based configuration software for easy setup
- Rev4 hardware
User Reviews
Be the first to review “NAZE32 FLIGHT CONTROLLER BOARD, 6DOF MULTICOPTER”
You must be logged in to post a review.
Vendor Information
- Store Name: expert.peshawar
- Vendor: expert.peshawar
-
Address:
Market
Peshawar
Khyber Pakhtunkhwa
25000 - No ratings found yet!

Optical Infrared Water Liquid Level Sensor Control Switch Favorable Level Sensors

DJI SOFT ANTI DAMPING ANTI VIBRATION ELASTIC RUBBER DAMPER FOR GIMBALS AND FC

A4988 StepStick Stepper Motor Driver Module (35V, 2A) with heat-sink

₨ 2,950.00
There are no reviews yet.