Name: UA741CN OP-AMP Operational Amplifier IC DIP 8
SKU: 13560
Price: 25.00 PKR
Availability: InStock

The UA741CN is a general purpose operational amplifier (op-amp) IC. UA741 OP AMP is a direct, plug-in replacement for the LM709, MC1439 and 748 in most applications. The UA741CN features improved performance over industry standards like the LM709

The UA741CN IC can operate with a single supply voltage of +5V to +18V. The input voltage range is ±15V, and the output voltage swing is ±12V. This means that the input voltage can be anywhere from -15V to +15V, and the output voltage can be anywhere from -12V to +12V.

The OP AMP UA741CN IC has a high input impedance, which means that it draws very little current from the input signal source. This makes it ideal for applications where the input signal is from a low-power source, such as a sensor or transducer. The UA741CN IC also has a low output impedance, which means that it can drive a wide range of loads without affecting the output signal. This makes it ideal for applications where the output signal needs to be amplified or routed to a long cable.

The UA741 IC is a general-purpose operational amplifier that is ideal for voltage-follower applications. The high common-mode input voltage range of the UA741 means that it can use with input signals that have a wide range of voltages. This is important for voltage-follower applications, where the input signal may be from a variety of sources, such as sensors, transducers, or other amplifiers.

The absence of latch-up in the UA741 also makes it ideal for voltage-follower applications. Latch-up is a condition that can occur in some operational amplifiers when the input voltages are too high. Latch-up can cause the amplifier to become unstable and produce erratic output voltages. The UA741 is immune to latch-up, making it a safe and reliable choice for voltage-follower applications.

Features : –

The UA741 can use to amplify input signals by a specified amount. This is useful for increasing the output power of an audio signal or for amplifying the signal from a sensor. The UA741 can also use to compare two input signals and output a high or low signal depending on which voltage is higher. This is useful for detecting changes in an analog signal or for performing logic operations. The UA741CN IC is a op amp IC that has a number of benefits, including:

Low cost
Ease of use
Wide range of applications
High performance
Reliable
A factor-of-ten increase in speed
Internal unity-gain frequency compensation
Improved common-mode rejection ratio (CMRR)
Reduced input bias current
Reduced input offset voltage

UA741CN OP-AMP Operational Amplifier Specifications : –

The UA741 can use to integrate an input signal over time. This is useful for measuring the frequency or amplitude of an input signal. The UA741 can also use to differentiate an input signal over time. This is useful for measuring the rate of change of an input signal. Here is a table of the UA741CN’s electrical specifications:

Parameter	Value
Supply voltage	+5V to +18V
Input voltage range	±15V
Output voltage swing	±12V
Gain bandwidth product	1 MHz
Common-mode rejection ratio	90 dB
Input bias current	10 nA
Input offset voltage	1 mV
Output impedance	75 Ω

UA741CN OP-AMP Operational Amplifier Pin Description : –

The UA741CN IC is a general-purpose operational amplifier (op amp) integrated circuit (IC). It works on the principle of negative feedback. Negative feedback is a technique used to amplify signals while reducing noise and distortion. It has eight pins, which are labeled as follows:

Number	Pin Name	Description
1 , 5	OFFSET NULL	Pin used for remove the offset voltage and balance input voltage.
2	INPUT-	Inverting signal Input
3	INPUT+	Non-Inverting signal Input
4	V-	Ground or Negative Supply Voltage
6	OUTPUT	Output of op amp
7	V+	Positive Supply Voltage
8	NC	Not connected