Name: L298N L298 Motor Driver 2A Dual H-Bridge PWM Control Module
SKU: 13953
Price: 350.00 PKR
Availability: InStock

L298N L298 Motor driver 2A Dual H-Bridge PWM Control Module can be used with motors that have a voltage of between 5 and 35V DC.

There is also an onboard 5V regulator, so if your supply voltage is up to 12V you can also source 5V from the board.

This L298 2a Dual Motor Driver Module with PWM Control USES L298N as the main drive chip, with strong driving ability, low heat and strong anti-interference ability.

L298 Motor driver contains a dual channel full H-bridge driver. This L298-N Dual H-bridge allows up two DC motors to be independently controlled in both forward and reverse directions via a microcontroller such as an Arduino.

Alternatively, the module is capable of driving a single 4 input stepper motor. It includes an optional on-board 5V regulator for powering its internal logic circuit so only one supply voltage is required (Vm = 6 to 12V).

Screw terminals allow for easy connection of the motor(s) and the power supply.

L298n 2a Based Motor Driver Module , using ST L298N chip can directly drive two 3-30V DC motor, and provides a 5V output interface, you can chip circuitry to 5V power supply, support 3.3V MCU control.

you can easily control the DC motor speed and direction, you can also control the 2-phase stepper motor, smart car essential.

Control signals are connected to popular goldpin connectors, allowing to connect the circuit to run boards, such as Arduino, using wires.

Through this DUAL H Bridge Motor Driver L298N can use the built-in 78m05 drive power supply parts of their work, but in order to avoid the voltage regulator chip damage, when using the driving voltage is greater than 12 v, please use the external power supply 5 v logic.

Features: –

Double H bridge drive
Chip L298N (ST NEW)
Logical voltage 5V
Drive voltage 5V-35V
Logic current 0mA-36mA
Drive current 2A per channel (MAX single bridge)
Max power 25W
Weight 30g
Small size 43*43*27mm ( approximately 1.75″ x 1.75″ x 1″)
Compatible with L297/L298 driver.

L298N L298 Motor Driver 2A Module with PWM Control Specifications: –

Driver Current:2A
Logical Current:0-36mA
Maximum Power (W): 25W
Current Sense for each motor
Heatsink for better performance
Power-On LED indicator
Driver Model: L298N 2A
Driver Chip: Double H Bridge L298N
Motor Supply Voltage (Maximum): 46V
Motor Supply Current (Maximum): 2A
Logic Voltage: 5V
Driver Voltage: 5-35V

L298N L298 Motor Driver 2A Module with PWM Control Applications: –

Drive DC motors.
Drive stepping motors
In Robotics

L298N L298 Motor Driver 2A Module with PWM Control Pin Description: –

Pin Name	Description
IN1 & IN2	Motor A input pins. Used to control the spinning direction of Motor A
IN3 & IN4	Motor B input pins. Used to control the spinning direction of Motor B
ENA	Enables PWM signal for Motor A
ENB	Enables PWM signal for Motor B
OUT1 & OUT2	Output pins of Motor A
OUT3 & OUT4	Output pins of Motor B
12V	12V input from DC power Source
5V	Supplies power for the switching logic circuitry inside L298N IC
GND	Ground pin