KY-020 Tilt Switch Sensor Module for Arduino

Sold by
sherjaan
@ sherjaan

The KY-020 Tilt Switch Sensor module is a switch that reacts to movement. It closes the circuit when it’s tilted to the side as long as it is moved with enough force and degree of inclination to activate the ball switch inside.

 150.00

Category:

KY-020 Tilt Switch Sensor Module is a metallic ball switch that will open/close the circuit depending on the angle its tilted at. It does not measure the angle.

The KY-020 Tilt Switch Sensor module is a switch that reacts to movement. It closes the circuit when it’s tilted to the side as long as it is moved with enough force and degree of inclination to activate the ball switch inside.

Depending on the tilt, a switch short-circuits the input pins. This happens due to the fact that the ball inside rolls back and forth and with the right tilt then short-circuits the contacts inside the housing.

A tilt switch is a switch with a small conductive ball inside. The ball opens the contacts when the switch body is tilted.

KY-020 Tilt Switch Sensor Module, this module in normally open circuit position. It is not designed to be a closed circuit when tilted at a sufficient angle. It is a sensor module that switches depending on the position of the metal ball inside the tiny box on it. When the module is inclined at a sufficient angle, the ball in the tiny box changes its position by rolling and the open circuit and closed circuit conditions of the module are determined.

KY-020 Tilt Switch Sensor Module and a digital interface, built-in 13 LED build a simple circuit to produce tilt warning lamp 13 comes with digital interfaces of the LED, the tilt switch sensor interface to access digital 3,when the tilt open Off sensor senses a key signal, LED lights, otherwise off.

The KY-020 Tilt Switch Sensor Module consists of a 10kΩ resistor and a metallic ball switch with bidirectional conduction that will open/close the circuit depending on its tilt degree. It does not measure tilt angle.

Specifications: –

  • Working voltage: DC 3.3V-5V ;
  • Working current: 20mA ;
  • Size: 4.5×1.1cm(approx)
  • Working temperature: -10℃+50℃;
  • Detection distance : 2-40cm; Effective angle: 35°
  • IO interface: 4 line (-/+/S/EN); Output signal: TTL Level
  • Adjusting mode: Multi resistance regulation

KY-020 Tilt Switch Sensor Module Features: –

  • This tilt switch sensor contains a small metal ball that will complete a circuit depending on the orientation of the module. The sensor is very basic, and detects changes in its tilt. It cannot measure the angle of its tilt.
  • There are numerous examples on the internet of code to operate this switch. A search of “KY-020 tilt switch code” will give you numerous examples.
  • Connection: The ground wire should be connected with the pin near the – on the board. The Data wire should connect to the pin near the S on the board. 5V is connected to the middle pin.
  • Board dimensions: 18mm x 14mm

Datasheet: –

misclab.umeoce.maine.edu/…/KeyesKY-020Tilt_Sensor_Instructions.pdf

Package: –

1 x KY-020 Tilt Switch Sensor Module

Related Products at majju.pk

User Reviews

0.0 out of 5
0
0
0
0
0
Write a review

There are no reviews yet.

Be the first to review “KY-020 Tilt Switch Sensor Module for Arduino”

Vendor Information

  • Store Name: sherjaan
  • Vendor: sherjaan
  • Address:
  • 5.00 5.00 rating from 2 reviews
KY-020 Tilt Switch Sensor Module for Arduino
KY-020 Tilt Switch Sensor Module for Arduino

 150.00

Majju PK
Logo
Reset Password
Shopping cart